Ghostly goings on – sew your own Halloween ghost costume

I’m normally a bit ‘bah humbug’ about the whole Halloween thing and have been known to put up one of those ‘No trick or treaters’ posters!

But then I had children who went to school and along came the Halloween disco…

Halloween ghost

Now, every year I let Honey decide what she’d like to dress up as and get my creative head on and design a costume. Previous years have seen me refashion a tunic top as a witches costume and get creative with a long drapey skirt and a coat hanger to make bat wings.

This year the request was for a ghost.

OK, so I could have gone for a sheet, plonked it over her head cut a couple of holes for the eyes and said “off you go!” but that would have been too easy.

This was a pretty straightforward make and everything except the face paints and tights I already had.

Want to make your own? Here are some brief instructions to create the look.

Fabric choices – something light weight as it will give a better drape. I used white polycotton sheeting for the main fabric. I also added an underskirt as I knew otherwise I’d not hear the end of the tight sticking issues – I used some standard (ish – it has a bit of a crinkle effect going on) white lining fabric

Ghostly going's on

1. I cut a large rectangle, folded at the head end that was long enough to reach the ground and went a bit further than each outstretched arm. To do this, I just got Honey to lie down on top of the fabric. You could be more accurate and take measurements.

2. Cut a head opening in the middle. Fold your doubled rectangle in half and cut out a curved shape at the corner – try using a plate/saucer. Don’t worry if it ends up too big – you can always sew it up a bit.

3. Make a vertical cut at the centre front from the head opening down – approx 20 cms long so that your child can get their head in!

4. Mark the ‘dress’ shape on your fabric after having folded it in half along the centre front and in half across the neck edge. If your fabric has a right and a wrong side, do this right sides together.

kimono shape

5. Cut along the lines and then stitch using your chosen seam allowance

6. Finish the edges (you will need to clip under the arms making sure you don’t clip your stitching). I just used the pinking shears everywhere.

8. Finish the edges of the centre front opening (that you created at 3) using bias binding folded in half.

7. Using your tape measure on its edge measure your desired neck opening. You are going to need this measurement to construct a hood.

8. Add seam allowances – one for creating a hem on the hood and another for joining the two halves together

9. Draw a hood shape. The bottom edge will be half your total measurement calculated at 8.

10. Cut out two hood shapes. Join down the curved edge. Finish the front edge of the hood.

11. Attach the hood to the neck edge. You may need to ease (I added a small pleat at the back!) or clip some of the curved edges to get it to fit.

12. Fold two approx 20 cms lengths of bias binding in half and stitch along the edge. These will make your ties. Attach ties to the top of the centre front opening on either side just below the hood.

Hurrah! You have now finished the main ghost costume.

Next up, add you finishing touches. I used my pinking shears and cut leaf shapes all the way round the bottom edge and around the end of the sleeves. As I knew the costume would be worn with tights I also made an underskirt. I used Tasia’s wonderful tutorial reducing the ease slightly as this is for a 7 year old. I added the same leaf shapes using my pinking shears to the underskirt too.

Little Miss Ghostie

Finally, I used Snazaroo face paints to add the ghostly make up and found some white eyeball covered tights!

Honey was unrecognisable!!

Advertisements